Technical data

DBW 2010 / 2012 / 2020 / 2022 / 300 / 350 9.The Repair
901
9 The Repair
9.1 General
The acts of repair will be defined in this section that will
be carried out on the heating devices dismounted from
the vehicle. Any dismounting act that is more detailed
than the way as explained here will invalidate all rights of
guarantee.
Only the spare parts from the proper spare part kit can be
used for the mounting of the device.
DANGER
The induction operates with high voltage.
It is possible to replace the parts indicated below also as
the heating device is in mounted status if there is
sufficient place.
- The heat constrainer
- The heat sensor
- The fan thermostat or regulation thermostat
- The thermal fuse
- The thermal fuse element
- The burner head
- The induction bobbin
- The flame regulator
- The combustion chamber
The sockets of the cable bunch must be separated from
the control device prior to the act of replacement because
otherwise there will be danger of death.
The excessive pressure in the cooling system must be
reduced by opening the cooling connection before the
heat sensor, heat constrainer or thermal fuse in the
heating devices equipped with the control device 1563/64
will be replaced.
If necessary, wait furthermore for the heating device to
cool down.