F016J10018A page 1 Models C12E & C14E Qc electric cylinder mower OPERATING INSTRUCTIONS
F016J10018A page 2 3L XX TYPF016xxxxxx 579 xx.xxkg BA IPX4 XXXX 1/min xxxxxxxxxxxx 230V ~ 50/60Hz XXXXW MadeinUK.
F016J10018A Page 3 A B C12E 1 7 35 12 5 4 C14E 10 C 11 D 13 14 15 16 18 19 17 20 21
F016J10018A page 4 E F 2 3 22 23 H G 30 31 32 33 34 10 -15 mm 24 25 26 27 28 29 26
Safety Notes Warning! Read these instructions carefully, be familiar with the controls and the proper use of the lawnmower. Mowing on banks can be dangerous: – Mow across the face of slopes – never up and down. – Always be sure of your footing on slopes or wet grass. – Exercise extreme caution when changing direction on slopes. – Do not mow excessively steep slopes. – Use extreme caution when stepping back or pulling the lawnmower towards you. Never mow by pulling the mower towards you.
Product Specification Cylinder mower Webb C12E Part number Rated power Blade width [cm] Height of cut [mm] Grassbox capacity [l] Self-propelled Rake Weight [kg] Protection class Serial number C12E C14E 340W 340W 30 35 9-32 9-32 32 32 • •* 23.5 28 / II / II See serial no 9 [rating plate] on machine * GB models only Intended Use Webb C14E Operating Controls This product is intended for domestic lawn mowing.
It is recommended for increased electrical safety to use a Residual Current Device (RCD) with a tripping current of not more than 30 mA. Always check your RCD every time you use it. If you want to use an extension cable when operating your product, only the following cable dimensions should be used: - 1.0 mm 2 max length 40 m - 1.5 mm 2 max length 60 m - 2.
E Regularly check for obvious defects such as loose, dislodged or damaged blade, loose fixings, and worn or damaged components. Check that covers and guards are undamaged and correctly fitted. Carry out necessary maintenance or repairs before using. If the mower should happen to fail despite the care taken in manufacture and testing, repair should be carried out by an authorised customer service agent.
Remove pulley 32 and belt 26 by removing 3 screws 27. Pull the cutting cartridge unit 25 out using the handle. Obtain assistance if required. Replace the cartridge and fit retaining screws 24. Slacken the idler pulley screw 34. Refit the pulley 32 and belt 26. Adjust the idler pulley 33 against the belt 26 and tighten idler pulley screw 34. Refit the drive cover 28. This method is the same for fitting or removing cartridge accessories.
Fault Finding The following table gives checks and actions that you can perform if your machine does not operate correctly. If these do not identify/remedy the problem, contact your service agent. Warning: Switch off and remove plug from mains before investigating fault.
It is in your best interests to follow the Operating Instructions for your mower/scarifier, as a properly cared for product should give many years of excellent service. Should you require spares always insist on genuine spares. Any damage caused to the product through the fitting of parts not made or approved by Webb Lawnmowers is not covered by the Guarantee. Your statutory rights are not affected by this guarantee. Guarantee Webb Lawnmowers guarantee this product against manufacturing defects.
Notes Your nearest dealer Webb Lawnmowers - Hobley Drive - Swindon - SN3 4NS F016J10018A 28-11-11
