Manual

DT311C/ DT311H
ENGLISH
4
OPERATION
Internal Baery
Warning!
!
The Internal baery pack should only be replaced by an authorized DT Research service
representave. Please contact your product and/or service provider for internal baery
replacement service.
Powering ON and OFF
To acvate the Tablet Modules basic, push and quickly release the Power Buon. The
display will come on in a few seconds. To put the DT311C/ DT311H in Standby mode,
push and quickly re
lease the Power Buon. To turn the DT311C/ DT311H off for extended
storage, power off safely using any soware funcon that
“
shuts down computer
”
provided in the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power
—
please use the
AC-DC adapter with the DT311C/ DT311H when seng up for the first me to
fully charge the internal baery pack. You may charge the ext
ernal baery pack
with it aached to the DT311C/ DT311H, or with the oponal external baery
charger kit.
NOTE:
When the baery pack(s) is (are) charging, the blue-colored Baery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
acvity and the LED stays dark, the baery pack(s) may have been drained
substanally. Try unplugging/ replugging the AC-DC adapter t
o the DT311C/
DT311H a few mes to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in
“
Standby
”
mode while not in use. Pushing briefly on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (
“
hold 4+ seconds
”
feature) to turn off the
tablet
—
this form of hardware shutdown is intended to be a mean
s of recovery
from lockups, and not as normal operaon.
5
ENGLISH
Start Up
If the power up (from Standby or otherwise) is successful, the appropriate interface will
be displayed aer a launch sequence of several seconds. The wireless LAN connecon
may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT311C/ DT311H may be configured using the ulies and methods dictated by
the soware op
erang system. The DT311C/ DT311H should be configurable for various
properes such as user profiles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT311C/ DT311H is oen delivered with an embedded (user-inaccessible) 802.11ac/
a/b/g/n WLAN adapter equipped with a hidden custom antenna.
T
• hrough the support of typical WLAN adapters, the DT311C/ DT311H should be able
to detect all 802.11 access points in the vicinity for you to select the access point of
your choice for connecon.
T
• he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT311C/ DT311H and
the access points have to match. The SSID is case-sensive and it is recommended
that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for secure
access.
W
• hen WEP/WPA/WPA2 is enabled, you may
need to consult your network admin-
istrator or your networking equipment literature to properly configure associated
sengs such as Authencaon mode, etc.
R
• efer to the access point operang manuals for seng up the 802.11 access points.