Owner's manual

WebDT Mobile Tablet Barcode Scanner Operation Guide
Mobile POS Tablet
Barcode Scanner
Buon Management
The default scanner trigger buon is on the right side.
To assign Scanner Trigger buon, follow the procedures
below.
1. Start Buon Manager by clicking on in the
system tray.
2. Select an available unused buon marked with the
icon .
3. Click on to go to the second screen of Buon Manager.
4. Click on the icon to assign the Scanner Trigger to the unused buon.
5. Click OK to apply conguraon sengs and close the window.
Installaon
The Barcode Scanner is preinstalled as an opon for the WebDT 390/ 390i.
www.dtresearch.com
Scanner 1/2
Barcode Scanner
Trigger Buon
Scanner Conguraon
To Add/Remove Symbologies, follow the procedures below.
1. Click Start | All Programs | DT Research | Buon
Manager | ScannerCong.
2. Select COM3 and click Connect buon.
3.
Add Symbology with buon and Remove
Symbology with
buon.
4. Select the Beep aer scanning barcode checkbox to
enable beep sound aer scanning bar code or deselect
it to disable the beep sound.
5. Click OK to apply the conguraon sengs and close
the window.
Note: Add only the needed symbologies for best performance.
WebDT 390/ 390i OPERATION GUIDE