User Manual
DT512
ENGLISH
2
3
ENGLISH
Packaging
The DT512 is packaged with recyclable materials and designed for maximum protecon in •
transportaon and handling.
When possible, please save the packaging carton and protecve inserts for re-use if there is ever •
a need to ship the DT512.
I/O Panels
Side I/O Panel
The DT512 has two USB 2.0 ports located and easily
accessible along the right edge of the display unit.
Lower I/O Panel
The DT512 has a comprehensive set of I/O ports. The
following ports are located along the lower rear edge of the
display unit.
RS232 COM port1.
Audio-out jack2.
Line-in jack3.
Microphone-in jack4.
Ethernet port (RJ45)5.
18.5V/ 3.5A DC-in jack6.
Lower Panel Funcon Buons
The boom of the DT512 features power, ulity, so keyboard and programmable buons.
Power buon7.
Programmable buons8.
Scanner port9.
Rear Mounng
The DT512 is designed to be secured to 75mm x 75mm VESA-compliant mounng arms or stands.
This is accomplished by detaching the standard metal base from the rear of the display unit. The
75mm x 75mm VESA-compliant mounng holes at the rear of the device will mate with VESA
mounts or arms to meet the requirements of the deployment.
Unscrew
the four screws aaching the 100mm 1.
x 100mm VESA-compliant adapter to the
display, then remove the adapter.
Aa
ch the new 75mm x 75mm VESA-compliant 3.
mounng device or stand to the display.
The display
without the adapter.2.
The d
isplay successfully mounted onto a 4.
VESA-compliant mounng arm.
7 8
1 2 39 4 5 6
May be configured to perform different funcons, depending on the soware operang •
system.
Depending on the OS, a brief, firm push will trigger soware-enabled entry into Shutdown •
or Standby modes. Push in similar manner to Restart or to exit Standby mode.
Push and hold for over 4 seconds to forcefully shut down the device.•
This method of powering off should only be used when proper shutdown through soware •
is not possible.
The fo
ur buons are intended to be user programmable via soware in applicable operang
systems.