Instructions / Assembly

14
2
3
4
7
8
1
2
6
5
MAIN BURNER IGNITION & USAGE
2 4 7 8
5
OFF START/HI MEDIUM LOW
The grills illustrated
in this Owner’s Guide
may vary slightly from
the model purchased.
MAIN BURNER IGNITION
Note: Summary lighting instructions are inside the left-hand cabinet door.
A) Open the lid (1).
B) Make sure all burner control knobs are turned off (2). (Push control knob in and turn
it clockwise to ensure that it is in the OFF position.)
m WARNING: The burner control knobs must be in the OFF
position before turning on the LP tank valve (3). If they are
not in the OFF position, when you turn on the LP tank valve,
the “excess gas flow control” feature will activate, limiting
the flow of gas from the LP tank. If this should occur, turn
OFF the LP tank valve and burner control knobs. Start over.
C) Turn the LP tank on by slowly turning the tank valve counterclockwise; wait 60
seconds before pushing the control knob in and turning it to START/HIGH (3).
Electronic Ignition System
Each control knob operates an individual burner, and each burner ignites with an
electronic igniter. The electronic ignition system ignites each burner individually with a
spark from the igniter electrode inside the Gas Catcher™ ignition chamber. You generate
the energy for the spark by pushing the electronic ignition button. You will hear it clicking.
D) Ignite the burners individually from left to right. Begin with the burner on the left; push
control knob in and turn it to START/HI (4). Push and hold in the electronic ignition
button (5). You will hear it clicking. Check that the left burner is lit by looking through
the cooking grates. You should see a flame (6).
m WARNING: Do not lean over the open grill.
E) Ignite center burner by pushing control knob in and turning it to START/HI (7). Then,
push and hold in the electronic ignition button (5). You will hear it clicking. Check that
the center burner is lit by looking through the cooking grates.
F) Ignite right burner by pushing control knob in and turning it to START/HI (8). Push
and hold in the electronic ignition button (5). You will hear it clicking. Confirm that the
right burner is lit by looking through the cooking grates.
m WARNING: Each burner must be ignited individually by
pushing the electronic ignition button. Failure to do so may
cause a flare-up of gas which can cause serious bodily
injury and damage to property.
m WARNING: If any burner fails to ignite during lighting, within
five seconds, stop, turn the burner control knob to OFF and
wait five minutes to allow the gas to clear before you try
again or light with a match.
◆
TO EXTINGUISH
Push in and turn each burner control knob clockwise to the OFF position. Turn gas
supply off at the source.
◆
m DANGER
When the “excess gas flow control” feature is activated,
a small amount of gas is still flowing to the burners. After
turning off the LP tank valve and burner control knobs, wait
at least five minutes for the gas to clear before attempting to
light the grill. Failure to do so may result in an explosive flare-
up, which can cause serious bodily injury or death.
m DANGER
Failure to open the lid while igniting the grill’s burners, or
not waiting five minutes to allow the gas to clear if the grill
does not light, may result in an explosive flare-up which can
cause serious bodily injury or death.