USB Module Manual iportproducts.
GET TO KNOW USB MODULE BOX CONTENTS: Power Supply USB Module Drill Template The USB module was designed as an add on to your LuxePort BaseStation. The USB module utilizes a larger power supply to provide charging to your iPad while docked to the Luxeport BaseStation as well as 2 additional 5W USB devices such as 2 phones, or 1 additional 10W device such as a tablet.
INSTALLING USB MODULE INTO BASESTATION Step 1 Insert the barrel connector from the provided power supply into the bottom of the USB module. Step 2 Remove the USB-C cable from the BaseStation if installed and slide the USB Module into the back of the BaseStation. Once completed, additional devices can now be charged.
UNDER MOUNT USB MODULE WIRE (OPTIONAL) Step 1 Remove security foot from the BaseStation and place in the desired location. For assistance in installation of the security foot, reference the BaseStation Manual. Step 2 To properly align drill hole, insert the provided template into the security foot as shown. 6 Step 3 Mark the center hole and use a 5/8” (16mm) spade bit to drill through the table or desk. Step 4 Run the power cable through the table and connect to the USB module.
For more help and info please visit: iportproducts.com/luxeport iPort 991 Calle Amanacer San Clemente, CA 92673 United States of America +1 949 226 5222 CAUTION: This product contains magnets. Do not place in direct proximity with magnetically sensitive objects such as credit cards or exposed hard drives. Persons with pace makers are not recommended to use this product. CAUTION: Use products as directed. Unspecified use could result in injury. Warranty can be found at iportproducts.
