Instructions / Assembly

10
GAS INSTRUCTIONS
LEAK CHECK PREPARATION
Check That All Burner Valves Are Off
Valves are shipped in the OFF position, but you should check to be sure that they are
turned off. Check by pushing in and turning clockwise. If they do not turn, they are off. If
they do turn continue turning them clockwise until they stop, then they are off.
m WARNING: The gas connections of your Summit
®
Gas Grill
have been factory tested. We do however recommend that
you leak check all gas connections before operating your
Summit
®
Gas Grill.
Remove Control Panel
Tools needed: Screwdriver and a towel.
A) Remove burner control knobs (1).
B) Open both doors. With a screwdriver, remove screws from the underside of control
panel (2).
C) Place a towel on the top of thr right door assembly.
This will protect control panel and door assembly from getting scratched on
next step.
D)
Tilt bottom of conrol panel forward and lift up and away from the grill (3) .
E) Fully open right door. Place control panel on floor, leaning against towel covering
right door assembly (4).
◆
2
4
1
3
The grills illustrated
in this Owner’s Guide
may vary slightly from
the model purchased.