GENESIS GOLD–B ® Gas Grill Owners Guide DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. Leaking gas may cause a fire or explosion which can cause serious bodily injury or death, or damage to property.
DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNINGS Do not store a spare or disconnected liquid propane cylinder under or near this barbecue. Improper assembly may be dangerous. Please carefully follow the assembly instructions in this manual.
Warranty Weber-Stephen Products Co.
Contents Danger & Warnings ....................................................................... A-2 Warranty ........................................................................................ A-3 General Instructions ...................................................................... A-5 Exploded View ............................................................................... A-6 Parts List .......................................................................................
Storage General Instructions • Your Weber Gas Barbecue is a portable outdoor cooking appliance. With the Weber Gas Barbecue you can grill, barbecue, roast and bake with results that are difficult to duplicate with indoor kitchen appliances. The closed lid and Flavorizer® Bars produce that “outdoor” flavor in the food. The Weber Gas Barbecue is portable so you can easily change its location in your yard or on your patio. Portability means you can take your Weber Gas Barbecue with you if you move.
1 Genesis Gold-B NG 2 3 4 5 6 7 34 35 8 9 10 36 37 38 11 12 39 13 14 40 15 16 41 42 43 44 45 17 18 19 46 39 20 21 22 23 24 25 47 48 17 16 26 19 27 18 28 49 50 29 51 26 52 53 30 31 54 32 55 33 A-6
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33.
© 1999 Weber-Stephen Products Co., Weber, the silhouette, and the kettle configuration are registered trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United States patents and patents in other nations globally. Printed in the U.S.A.
Remove Packaging from Grill Remove all tape from packaging. Remove bottom rack from top of packaging. Remove outer box. Pull out bottom tray from cooking box. Remove packaging material from bottom tray, catch pan holder, catch pan, and drip pan. Remove Grill from Lower Packaging WARNING: Lifting the barbecue from the lower packaging requires at least two people. With two people: lift straight up and over lower packaging and cardboard support.
You will need: 1/2 inch bolts (1/4 x 20 x 1/2 inch bolts) - 4 Phillips screwdriver 7/16 open-end or an adjustable wrench Nylon Washers - 4 Flavorizer Bars - 5 Left Work Surface - 1 Cooking Grates - 2 Condiment basket - 1 Right Work Surface - 1 Bottom Shelf - 1 12 Foot Hose - 1 Slide Out Buttom Tray - 1 Catch pan holder - 1 Catch Pan - 1 Disposable Drip Pans - 2 A-10
Assembly Instructions Install the slide out bottom tray You will need: the slide out bottom tray(1), catch pan holder(2), catch pan and one disposable drip pan. (1) Slide the bottom tray onto the mounting rails under the cooking box with finger grip toward you(1). WARNING: Do not line bottom tray with aluminum foil. It can cause grease fires by trapping the grease and not allowing grease to flow into the catch pan. (2) Hook the ends of the catch pan holder into the hole in the slide out bottom tray.
Install Flavorizer® Bars and Cooking Grates You will need: five Flavorizer Bars and two cooking grates. Place the Flavorizer Bars side by side in the cooking box. Installing the warming rack You will need: warming rack. Set the warming rack into the slots at the rear of the cooking box. Set the cooking grates onto the ledges in the cooking box with the rounded sides up. Install the bottom shelf You will need: Bottom shelf.
Installing Work Surfaces & Gas Connection Guidelines Install Left Work Surface You will need left work surface, two 1/2 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench. Insert the left work surface tabs in the slots in the frame(1). Slip washers on the bolts and insert the bolts as shown(2). Tighten (1) Check that all burner valves are off You will need: burner control knobs. Valves are shipped in the OFF position, but you should check to be sure that they are turned OFF.
Install Gas Supply General Specifications for Piping Note - Contact your local municipality for building codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must confirm to the latest edition of ANSI Z223.1. WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL. Some of the following are general requirements taken from ANISI Z223.1 latest edition for complete specifications. ■ This barbecue is designed to operate at 7 inches of water column pressure (.2526 psi).
Check for gas leaks DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion which can cause serious bodily injury or death and damage to property. WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested.
Reinstall control panel (after checking for gas leaks) (1) Set the control panel in place over both sides of the frame. Hold the crossover ignition button up while setting the control panel in place. (2) Line up the control panel with the white plastic plugs in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. (3) Push each of the burner control knobs onto their valve. (4) Reinstall Side Burner cover.
Operating 1) Open the lid. 2) Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise to ensure that they are in the off position.) 3) Turn the gas supply valve on. WARNING: Do not lean over the open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue. 4) Push Front burner control knob down and turn to START/HI. 5) Push the Crossover Ignition Button several times, so it clicks each time.
WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match. 7) After the FRONT burner is lit you can turn on the other burner or burners. Note - Always light the FRONT burner first. The other burner or burners ignite from the FRONT burner.
■ Check that the areas under the control panel and the slide out bottom tray are free from debris that might obstruct the flow of combustion or ventilation air. ■ The Spider stopper guards should also be checked for any obstructions. (See “Maintenance” Section.) Cooking WARNING: Do not move the Weber Gas Barbecue when operating or while barbecue is hot. You can adjust the FRONT and BACK burners as desired.
Check: 1) Hose-to-manifold connection. WARNING: If there is a leak at the hose-tomanifold connection(1), retighten the hose fitting with a wrench and recheck for leaks with soap and water solution. If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual. 2) Valves-to-manifold connections. 3) The hose-to quick-disconnect connection.
Main Burner Flame Pattern General Maintenance The Weber Gas Barbecue burners have been factory set for the correct air and gas mixture. The correct flame pattern is shown. 1) Burner tube 2) Tips occasionally flicker yellow 3) Light blue 4) Dark blue Weber Spider Stopper™ Guards Your Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (Venturi(1), air shutter(2), venturi fin(3) ) of the burner tubes.
7) Lift and twist the burner assembly slightly, to separate the crossover tube(1) from the burners. Remove the burners from the cooking box. Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool. 2) Turn gas OFF at source. 3) To remove control panel: take off the burner control knobs. Remove the screws holding the control panel in place. Lift off the control panel. 4) Unlatch the Spider Stopper™ Guards and remove them. (1) 8) To reinstall the burners, reverse 3) through 7).
9) Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins(1). There should be no gaps in the seams or in the fit around the burners(2) and valves(3). Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Left burner, light the Left burner with a match. If the Left burner lights with a match, then check the Crossover Ignition System.
Troubleshooting Problem Check Cure Burners burn with a yellow or orange flame, in conjunction with the smell of gas. Inspect Weber Spider Stopper Guards for possible obstructions. (Blockage of holes.) Clean Weber Spider Stopper Guards. (See Section “Annual Maintenance”) Burner does not light, or flame is low in HIGH position. Is fuel hose bent or kinked? Straighten fuel hose.