Service manual

ROUTINE MAINTENANCE
To ensure long service life and to maintain the tender in a safe and reliable condition
please follow these routine maintenance instructions. Williams cannot accept any
responsibility for damage or injury resulting from incorrect maintenance or improper
adjustment carried out by the owner.
1. Re-pack shaft seal approximately every 10 hours of operation with Quicksilver marine 2-4-C
grease, or equivalent high temperature, high speed bearing grease. As a guide use two pumps of
the grease gun supplied with the tender. Take care not to over-pressure seals and wipe away
excess grease.
2. Check engine oil level.
3. Check coolant level.
4. Flush open loop cooling system.
5. Apply a good quality marine grease containing Teflon (e.g. Quicksilver 101) to all control cables
both under the helm and at the pump.
6. Check bilges for water ingress, oil or fuel contamination.
7. Lightly grease the extending running light pole using white grease or similar.
8. Check condition of the 2 pump anodes.
9. Loss of tube pressure over 24 hours is not unusual. Temperature and atmospheric pressure will
affect tube pressures. Check pressures regularly.
WINTER STORAGE
Refer to the Williams service manual for winterisation procedures.
OWNERS
HANDBOOK
Williams Performance Tenders Ltd.
Vogue Business Park, Berinsfield, Oxfordshire, OX10 7LN, United Kingdom
T: [phone] F: [phone] W: www.williamsmarine.com
LIMITED WARRANTY
This boat is intended for pleasure use only. It is covered by a limited warranty which applies for defects and flaws, which may occur,
despite normal use and regular maintenance, for a period of 2 years for hull and 3 years for tubes from the date of registration.
Full warranty terms are contained within the Williams service manual.
SUPPLYING DEALER STAMP:
9910_WILLIAMS MANUAL REPRINT.indd 1-2 27/11/06 17:10:10