Owner`s manual

Step 18

Add control panel and burner control knobs

You will need: control panel, two Phillips screws/washers,

a Phillips screwdriver, and three burner control knobs.

Set the control panel in place over both frame braces.

(Hold the Crossover Ignition button up while setting the

control panel in place.) Line up the holes in the control

panel with the holes in the inserts in the frame brace.

Insert screws and tighten with a Phillips screwdriver until

snug. Do not overtighten. Figure 23 (a).

Push on the burner control knobs. Figure 23 (b).

Figure 23

Insert in

frame brace

Control panel

Phillips screws/

washers

(a)

(b)

Crossover

Ignition

Button

Step 19

Install swing table

You will need: swing table end bracket, two 10-24 hex

nuts, two 10-24 x 1 3/4 inch machine screws, slide bar

assembly, swing table, four nylon washers, screwdriver

and pliers.

Allow the slide bar to hang down. Push the support rod

into the lower support bracket. Figure 24 (a). Swing the

rod up so you can slide the rod all the way inside the

locking tab. Figure 24 (b). The rod should swing freely

inside the locking tab. Figure 24 (c).

Figure 24

(a)

(b)

(c)

Support rod