Installation Guide

Diagnostics
Understanding your LINK 240
You can monitor the system operation of your LINK 240 by looking at the green system LED and referring to
the table below.
Important: The LINK 240 device must be activated in WEBFLEET.
GREEN LED mode
OFF Unit is in standby mode or is not connected to power.
Switch on ignition.
Check if the device is properly connected to power.
OFF and short ON every 3sec Ignition off (not detected).
Flashing No operating system and/or no application available or
application failed.
Contact the Webfleet Solutions support team at
www.webfleet.com/support.
Rapidly flashing (YELLOW LED is OFF) Reset to factory settings
ON and short OFF every 3sec Ignition on. Application is running, device is not activat-
ed.
Activate device.
ON Application is running, device is activated.
You can monitor the connection of your LINK 240 to the mobile network by looking at the yellow connec-
tion LED and referring to the table below.
YELLOW LED mode
OFF Not connected - No mobile network coverage.
Check if device is connected to power. Switch on ignition.
Move the vehicle as you may be in a mobile network
dead spot.
OFF and short ON every 3sec Not connected - Correct mobile network operator not
avaialable.
Check contract for mobile network roaming support.
Move the vehicle as you may be in a mobile network
dead spot.
Flashing SIM not in place; SIM defective; Modem problem.
In case of SIM modem issues, please contact the Webfleet
Solutions Customer support at www.webfleet.com/sup-
port.
12