Installation Guide
Table Of Contents
- Installation
- Addendum
- Important Safety Notices and Warnings
- Prohibited uses
- CE mark and Radio Equipment Directive for LINK 240
- FCC information for the user
- Specific Absorption Rate (SAR) compliance
- Environmental and Battery information
- Triman logo
- Operating temperature
- WEEE – e-waste disposal
- How Webfleet Solutions uses your information
- Exposure limits
- Technical Specifications
- Model numbers
- Responsible party in North America
- Customer support contact
- This document
- WEBFLEET Telematics Service Platform
- Accessories supplied with this device
- Terms and conditions and Limited warranty
- Copyright notices
- Webfleet Solutions Limited Warranty
Safety first
Important safety notices and warnings
Important: Read the following safety instructions carefully.
Webfleet Solutions accept no liability for damage that results from disregarding the safety instructions. This
document is part of the product. Keep it in a safe place. If you pass the unit on to a new user, make sure
you give them this document as well.
Positioning
Position the device in such a way that it doesn’t block or interfere with your view of the road, the controls in
your vehicle, or the rear-view mirrors and airbags.
Danger of explosion
Parts of this product can cause sparks that can lead to explosions. This may endanger human health and life.
Do not use the unit in areas with high risk of explosion. When using this product in a vehicle fuelled by liq-
uefied gas, follow the safety regulations of the country in which the vehicle is operated.
Damage caused through improper installation
The installation and initial operation of the unit must be performed by authorised personnel only, for exam-
ple, a qualified radio dealer or an automotive electronics workshop.
Risk of injury in case of accidents
Do not mount the unit or accessories in the inflation area of airbags or in the impact area for the head or
knees. Choose an installation location that will avoid interference with displays, safety equipment and con-
trols.
Damage to the chassis
Make sure you do not drill into parts of the chassis that have structural or security-related functions. This is
because you cannot be certain that they will function properly after modification.
Repair and replacement
Repairs must be carried out by authorised and qualified personnel only. Never replace damaged parts of the
unit yourself. Send the defective unit to Webfleet Solutions for repair. Only the qualified staff of Webfleet
Solutions are authorised to repair or replace parts.
Damage to the device
Short-circuits inside the unit can be caused by contact with water or other liquids. The unit may be dam-
aged by contact with water. Use and store the unit in an area protected from water.
6