User guide

 Transmission distance of the chosen cable will be various based on reduction rate of 750MHz

(reduction rate of dB/100m < 25dB is recommended)

 Foamed or high-foamed trishield cable is recommended.

 Impedance 75Ω must be used for coax cable connection and connector work.

 Beware of deformation of cable due to high pressure over the cable.

 Don’t pull the cable with too much force.

 For DVR input/output, cables will be tied at the rear of the rack. If tied too tightly, inside/outside insulator can be

deformed so tie it loosely within cable’s curvature range.

Connecting a power cord

When power cord is connected, DVR starts booting automatically.

How to turn off DVR while it is operating : press power switch for 5 seconds, and a pop-up window will appear,

then select “YES” to turn off the power. For turn back on the power again, push the Power button.

Connecting an audio

Please see the below picture and use RCA cable to connect audio input/output devices to DVR

Connecting external device

Connecting USB Device

USB port can be used for copy of recorded data and for mouse.

See below table for USB Device specifications.

<Note>

USB stick needs to be FAT32 formatted.

DVR may not recognize USB Flash memories that require additional program on MS Windows.

Connecting eSATA Device

If external eSATA storage is used, it can be connected to a rear eSATA port. Additional power for eSATA device

will be required as DVR doesn’t supply power.

<Note>

1. Check compatibility of eSATA with DVR as not all eSATA are compatible with DVR.

2. If eSATA is connected to DVR when it is on, it may not be recognized depending on external devices. So

we recommend following the below steps.

1) Turn off DVR.

2) Turn off eSATA then connect it to DVR.

3) Turn on eSATA.

4) Turn on DVR.

Connecting NS04R

Connecting to DVR

(1) Connect NS04R to DVR using Gigabit Ethernet cable.

(2) NS04R’s DVR Port and DVR’s Storage Port must be connected directly.

* For more information and setup of NS04R, please refer to “NS04R user manual”.

USB specifications

Ver 2.0 or later

Usable device

USB Stick

Voltage specifications

DC 5V / Max. 200mA