User guide

25
<Note>
1) Use Gigabit Ethernet Cable(Category-6) for Network cables to connect to DVR. Other cables are not
compatible with Webgate DVR.
2) NS04R and DVR must be connected by cables and normal operation isn’t guaranteed if Hub is used.
Set ID configuration
Set ID using Rotary switch located at rear panel.
Set each different ID in case of over 2 NS04Rs are
connected.
Using tool such as Driver to set ID. For Group ID swich, it is
set as ID in a unit of 10 when ID switch of NS04R is in a
unit of 1.
ID setup value must be within 0~99.
EX) ID will be 23 when switch is set as Group ID=2,
NS04R ID=3
<Note>
1) It approximately takes a minute to turn on the power and to connect NS04R to DVR.
While it is connecting, 4 LEDs on the front will be turned on in order and all 4 LEDs may be turned on or
off when it is connected to DVR. HDD list can be checked on the disk manager.
Connecting input/out terminals
Wire end handling
See below for wire end handling used in terminal block. Please work on single line and multiple line as they
have different thicknesses.
Wire insertion/removal
As shown in the picture, push the lever to insert or remove a
wire.
Connecting the sensor
specification
below requirements need to be met in order to connect the sensor
Specifications
Input Channel #
16EA Transistor input
Input Type
N.C, N.O support
Supported sensor
Dry contact sensor
- Multiple lines : Peel off the recommended length(8~10mm) and lead-coat it. Use AWG 22 ~ 26.
- Single line : Peel off the recommended length(8~10mm) and use AWG 20 ~ 26.