User guide

PTZ

At PTZ menu, PTZ’s serial port per each channel, Protocol, PTZ address

and Baudrate can be configured. Additionally, PTZ home function, Idle

time, Parity bit, Stop bit can be configured.

HDD registration and format

After mounting HDD and booting, “Disk Manager” will run

automatically as shown in the right picture.

If it doesn’t run, please check the connectivity of HDD

(1) Select a HDD among listed HDDs. Activate the HDD and execute

format.

(2) Check “YES” for the fomatted HDD..

warning

Please call Webgate or Webgate dealers for HDD compatibility

HDD replacement

(1) turn off the DVR, take out a HDD and install a new HDD.

(2) turn on the DVR again, open “Disk Manager”. Select the removed HDD, and press [Confirm] to remove the

HDD from the list.

(3) Select the newly installed HDD and format it after completing the activation.

(4) check the enabled box “YES” for the fomatted HDD.

<Note>

HDD re-use

You can use HDD that has been used before from DVR, without deleting its data.

Install the previous HDD in the DVR, select from the list and activate it. Enabled box will be checked “yes”.

Remote monitoring and control

Via Internet/Intranet, user can use PC to control from the remote site. Enjoy the same control over DVR

through PC as you’d have on the spot from the remote site.

Ethernet Connection

Turn off DVR, connect Ethernet cable to DVR and turn it back on.

To protect DVR from damage, after connecting Ethernet cable, input Power.

Plug in ethernet cable tightly. Input power on DVR and check its connectivity.

Menu  device  PTZ

menu  system  disk