User guide

Network

Configure network info when DVR is connected to a network.

Network settings

used to configure the relevant network info when DVR is connected

to network.

type

Select Network type(Ethernet/xDSL). If DVR is connected to cable

modem or lan, select “Ethernet.

If DVR is connected to xDSL, PPPoE type, select xDSL. But if it is not

PPPoE type, even if it is xDSL, select ‘Ethernet’.

DHCP

If Network to which DVR is connected has a DHCP server, it,

assuming it is enabled, will automatically assign IP address to DVR.

IP address

IP Address is for the connection between DVR and Control Center and also for web connection from

Webviewer. (But, Net Mask, Gateway should be configured.).

Net Mask

Net Mask makes range of IP address available.

Gateway

Gateway address must be entered for DVR to connect to external network and gateway address is given by

network administrator.

DNS server

DNS must be entered in order to use various networks such as, WRS, NTP, e-mail, and twitter. Contact network

administrator for DNS address.

UPnP Port Forwarding

When using Internet Sharing device supporting UPnP, this function eable all connected DVR to do Port

forwarding and they can be connected to Internet with IP address of Internet Sharing device.

(1) Configure two DVRs with DHCP On.

(2) Please, check if DVRs which are connected to Internet Sharing Device are allocated with official IP.

(3) Configure DVR port of DVR(A) and DVR(B) as 81 and 82 individually.

(4) Configure UPnP function of Internet Sharing Device as “ON”.

(5) Configure UPnP Port Forwarding function of DVR as “ON”.

(6) Please, check if Port Forwarding Status message is changed from “Not Available” to “Port Mapping is

OK”.

(7) Finally, if user accesses DVR(A) with the IP address with port number 81 or DVR(B) with the IP address

with port number 82, user can access DVRs.

Port

Default port is 80 and be careful in entering the port # when used with PPPoE modem and router.

menu  network  network  Ethernet