User guide

63
Motion detection
The Motion detection can be used to notify user
of detected motion on each channel or all channel.
Channel
Configure All or each channel.
Sensitivity
Sensitivity can be configured from min.1 to max 10.
Area
Area configure detection when a motion is triggered.
User can select all or clear all. In case of configuring each channel, it is
available to set all, clear all or define user area.
user area
When selecting a channel, user area can be configured.
1 grid size is 15x10 and factory default value is “All grid selected”.
Press “change area” button to open motion detector enabled area set
up window.
Users can set motion detection area in screen. The motion detection
zone by setting is indicated in translucent green.
If an area is set up when motion detector set up start point is enabled, all values will be applied as disabled
and if set up when motion detector set up start point is disabled, then all values will be applied as enabled.
In other words, opposite set up to the value of the initially selected area will be applied.
sensor
This menu is to setup the existing sensor input and the type of
sensors. If sensor is selected as N.O, or N.C. it is applied to all
channels. Users can set different options like N.O, N.C, or Off after
selecting each channel.
Name
description
Normal Open
If sensor's electric contacts become connected,
DVR recognizes it as an alarm.
Normal Close
If sensor's electric contacts become
disconnected, DVR recognizes it as an alarm.
menu  event  motion
menu  event  sensor