User's Manual

WebEye WebEye B101B101 User’s Guide
21
4) Dynamic IP registration service for ISDN and xDSL users
This page is to register WebEye on dynamic
IP registration server.
If WebEye is installed on a network of
dynamic IP address (floating IP address),
administrator should register the WebEye to
‘dynamic IP registration server’ to give
simple connectivity to common users.
To solve the problem WebGate run a server making a list of WebEyes that have dynamic IP addresses. On the
server, WebEye registers its information such as name, location, and description, so that common users may
detect a certain WebEye. Name, location and description are assigned at ‘System Configuration’ page. If
administrator does not change them, the WebEye will register default information on the list, and it will be
very difficult to point out and access a certain WebEye. The list is on an Internet homepage of WebEye,
‘www.webeye.to’.
(1) Auto IP Registration Function
Administrator may register one’s WebEye by enabling ‘Auto IP Registration Function’. Registration process
is that WebEye detects IP addresses from DHCP server and informs the detected IP addresses to dynamic IP
registration server. And the server updates already registered information with new one. Please keep in mind
that user have to enable ‘DHCP Client Protocol’ at ‘Network Configuration’ page to have WebEye get
dynamic IP addresses automatically, when WebEye is installed on a network of dynamic IP address.
(2) Registration Server Address
This is to configure a server address for registration. The registration server to be used for Dynamic IP
registration should be installed proper S/W, developed by WebGate Inc. If you do not run a server for IP
registration, keep the server’s name as default figure (webeye.to).
(3) Registration Interval
Dynamic IP address is commonly used on xDSL, ISDN or Cable Modem lines. To maintain continuous
connectivity, user should reset the ‘Registration Interval’ shorter than the default value. Because an IP is to be
changed from time to time, some user may not access by clicking on a WebEye if actual information on
WebEye is changed from the registered IP information on the dynamic IP registration server.
(4) Add Public List
There are two registration systems. One is to register on a public list and another is on a private list. Please
refer to Article 3)
•
Public List : This list is open to anyone who accesses WebEye Internet homepage
(www.webeye.to).
• Private List: This list is not seen to anyone. Even the owner of a WebEye can get the information on
one’s WebEye only without viewing information on other’s WebEye.
(5) Access Token
Access token is a password and it is used when you register your own WebEye on a list ‘User’s WebEye’ out
of all WebEyes on WRS(WebEye Registration Server.)