User's Manual
WebEye WebEye B101B101
User’s Guide
25
Administrator assigns FTP server address, FTP user account, FTP user password, and FTP user path to
receive files when events occur.
(6) FTP event configuration
Administrator may set sending conditions, image resolution, and filename. Image resolution, filename, and
sending conditions setting methods for FTP are same as that of e-mail.
9) Pan/Tilt/Zoom Configuration
This page is to select which serial port to
use and to configure PTZ functions such as
‘Mode’, ‘Preset’, etc.
(1) Select Serial Port
It is to select a serial port among ‘Serial
#1’, ‘Serial #2’, and ‘Serial #3’ with which a pan/tilt/zoom control receiver is connected to WebEye. Serial #1
and Serial #2 are RS232C interfaces and Serial #3 is RS422/RS485 interface.
(2) Serial Port Base Address
This menu is to identify the base addresses between WebEye and a dome camera. Administrator may connect
analogue PTZ controller as well as WebEye B101 to a dome camera. And an analogue PTZ controller can be
connected with several dome cameras.
(3) Advanced
You may register preset points and configure mode.
When you register preset, you would better stop other user control PTZ mechanism. If not, other users may
disturb you in setting preset.
New Preset
You register a new preset point as follows. You may register up to 64 presets.
• Focus on a certain point to register as a preset point controlling PTZ mechanism.
•
Click ‘New Preset’ button, then a dialog box ‘New Preset’ appears.
• Select a number from 1 to 64
• Set the preset name.
• Click ‘Add/Change’ button
• In ‘Current Preset List’ panel, you may view preset points that are registered currently . At the bottom of
this window, you may check if the selected number is occupied or not.
New Group
You make a new group with combining registered presets. You may make and list up to 6 groups. Each group
is to contain 64 points. The procedure to make a group is as follows.
• Click ‘New Group’ button, then a dialog box ‘New Group’ appears.
•
Select a number from 1 to 6.
• Set the group name.
• Set interval time. This signifies a duration from time when to move to the next preset point to time when
to move to the one after the next preset point.
• List proper preset point among registered ones in ‘Current Group Member’. According to the order that