User's Manual

WebEye WebEye B101B101 User’s Guide
26
you listed in a group, a dome camera travels.
• Click ‘Add/Change’ button
• In ‘Current Group Member’ panel, all registered preset points appear. At the bottom of this window, you
may check if the selected number is occupied or not.
Mode
There are three modes like ‘Normal Mode’, ‘Swing Mode’, and ‘Group Mode’.
• Under normal mode, user may control PTZ mechanism of a dome camera with corresponding buttons in
control panel. If you activate ‘Give/Take Mode’ each user is to be permitted to control the PTZ
mechanism for a certain period of time on a first-come-first-served basis.
• If swing mode is selected, the connected dome camera swings between the designated points. Time
duration of ‘Wait (some) seconds’ signifies the same meaning that of group mode.
• If group mode is selected, the dome camera travels among listed preset point according to the listed order.
10) Serial Port Configuration
This page is to select a communication
protocol among listed ones.
(1) Serial Port Selection
Administrator selects a serial port to
configure. WebEye B101 has three serial
ports. ‘Serial #1’ and ‘Serial #2’ are
RS232C interface ports, and ‘Serial #3’ is a RS422/RS485 interface port.
(2) Select Attached Device
Administrator selects a communication protocol that an attached external device satisfies among already listed
protocols. WebGate has listed protocols of Philips, Pelco (P and D), Sensormatic, and Video Technical.
Audio Device
This protocol is for WebEye A10, which is an audio transmission device connected to WebEye B101.
Control Parameters
With listed protocols of Philips, Pelco, Sensormatic and VT, you may also configure its control parameters
such as ‘Baud Rate’, ‘Stop Bits’, ‘Data Bits’, and ‘Parity Check’ according to connected dome camera
settings.
Manual Setting
If your mechanism doesn’t use any of already listed protocols, you may define the protocol manually by
selecting ‘Manual Setting’ and set parameters through ‘Control Parameters’ and ‘PTZ CMD’ menus.
11) Digital I/O Configuration
This page is to configure digital input status.
This is related with E-mail and FTP
applications and PTZ preset points.
(1) Device Type for Input Ports
Administrator defines active state of 4 digital
input ports. If you connect normal open type