User's Manual

WebEye WebEye B101B101 User’s Guide
27
device to input port, you should select ‘NO (Normal Open)’. With normal close type device, you should select
‘NC (Normal Close)’.
(2) Current State for Input Ports
WebEye shows current states of the 4 digital devices connected to 4 input ports. In the status panel, active
state or de-active state message shows. ‘De -Active State’ means that connected device didn’t detect any event
when ‘Apply button’ is clicked.
12) Alarm Configuration
This page is to set conditions for recording
images during event situation, so that WebEye
sends the images through e-mail or FTP.
(1) Motion Detection Threshold
Administrator sets threshold for motion detection
function. Threshold ‘0’ is the most sensitive state
and ‘900’ is the dullest state.
(2) Alarm Parameters for E-mail / FTP
Application
Administrator defines conditions for recording
image to WebEye, if WebEye detect events
through motion detection unction (MD Event) or
external devices (SID1, SID2, SID3, and SID4).
WebEye can record 2 frames for 2 seconds
before the event and 2 frames for 2 seconds after the event as well as 1 frame at the moment of event. Its
maximum recording rate is 1 frame per second and the total fames are maximum 5. WebEye records the
images and send them through e-mail or FTP according to preset conditions on ‘Application Configuration’
page and ‘Alarm Configuration’ page. If event lasts long,
(3) Alarm Preset
This is to match a certain preset point to one of the external devices such as an infrared sensor. You may
designate any of registered preset point for each external device. If you enabled this function with matching a
certain preset with a external sensor, the connected dome camera pans, tilts and zooms to preset degrees.
13) User Custom Configuration
This page is to customize TCP ports of data
transmission and default viewer composition.
(1) Web Server TCP Port
Administrator assigns a web server TCP port
through which people can access WebEye and
WebEye sends data. 80
th
port is assigned default
value.
(2) Video Server TCP Port
Administrator assigns a video server TCP port
through which WebEye transmits images to users. 8080
th
port is assigned as default value.