User's Manual

WebEye WebEye B101B101 User’s Guide
8
2) Rear view and description
3) LED of Ethernet port
Yellow LED: This LED indicates the status of data transmission. After power is supplied, it is on for the first
4-5 seconds and then it goes off. And it blinks continuously when a user access WebEye and WebEye
transmits data.
Connector Name Description Remark
DIP switch
To designate video signal termination of ‘Video Input’
BNC connector. (Only the left switch is used)
Article 4)
Video Input To input video signal through a coaxial cable.
Video Output
To output video signal through a coaxial cable.
(Roof-through from ‘Video Input’ BNC connector)
RS-232
To communicate between WebEye and external devices
such a dome camera, WebEye A10 (An audio transmission
kit), or an external modem. These pins are for devices that
satisfy RS-232C protocol, and they are consisted in RX1,
TX1, and GND.
RS-232
To communicate between WebEye and external devices
such a dome camera, WebEye A10 (An audio transmission
kit), or an external modem. These pins are for devices that
satisfy RS-232C protocol, and they are consisted in RX2,
TX2, and GND.
GND pin is
co-used.
RS-422
To communicate between WebEye and a dome camera that
satisfies RS-422 protocol. They are half-duflex. It is
consisted in R+, R-, T+, and T-.
RS-485
To communicate between WebEye and a dome camera that
satisfies RS-485 protocol. They are consisted in 485+ and
485-. Short R+ and R- with a wire to get RS422+ and short
T+ and T - to get RS422-.