User manual

The WebMux Pro and Model WM108E User Guide – Version 5. 8 Rev15

Enter Admin http Port Number:

This is http port number for accessing Management Console in non-secure

mode. Any unused port number can be used. Factory default port number is 24,

one could choose to use any unused port below 10214 or port number above

1024 for this. Using port number above 1024 will need to setup an admin farm.

This farm is for preventing port collision in case passive FTP is one of the farms.

Using port number below 1024 will not need to setup this farm.

Enter Admin https Port Number:

This is the https port number for accessing Management Console in secure

mode. Factory default port number is 35, one could choose to use any unused

port below 1024 or port number above 1024 for this. Using port number above

1024 will need to setup an admin farm. That is for preventing port collision in

case passive FTP is one of your server farms. Using port number below 1024

will not need to have this farm.

Discard Changes Made?

User can select Yes at this point, all the changes made will be discarded. By

default the answer is NO, all the change will be saved to internal solid state

storage. Changes will take effect after next reboot.

The next question will be Reboot Now?

Reboot now?

This is the end of initial configuration. Most of the setup or changes require a

reboot to take effect. Press and hold the center Check-Mark button to make the

WebMux reboot. User UP arrow button to “Discard Changes” and “Yes” to exit

without change.