User manual

The WebMux Pro and Model WM108E User Guide – Version 5. 8 Rev15

Rear View

Server LAN Port

Connect this port to the Server LAN switch or hub. This port connects to the

servers and your local computers. It is the right most RJ45 socket. In Out-of Path

configuration, this is the only Ethernet cable to be connected.

Backup WebMux Port

Optionally, you may connect another WebMux to this port so that you can have

redundancy. If you have more than one WebMux, you can connect them using

cross over cable, or regular cable with a hub.

Router LAN Port

Connect this port to the Router LAN switch or hub. In most situations, this port

connects to the Internet side network in NAT mode. It is the left most RJ45

Socket.

Please note: The Router LAN and Server LAN port are not interchangeable.

External Modem Connect Port

To utilize the phone pager function of the WebMux, please connect the external

modem to this port. In some cases, if you prefer support engineers not using

diagnostic port over Internet, our support engineers can also connect through

modem to assist you for setup issues. An USRobotics V.Everything modem is

required, US Robotics part number 3CP3453. Modem dip switch has 3, 8, and 10

down, rest up. A standard external modem cable also needed. Check with your

modem supplier for the cable.

Power Switch

This switches the WebMux on and off. When in the "off" position, the front panel

power switch is disabled.

Power Cord

Please use the supplied power cord to connect the WebMux™ to power source.

1U WebMux has a 115V/230V AC universal power supply.