User Manual

11
Need help? Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
www.weboost.com
ENGLISH
Signal Booster Specifications
Connect 3G-X
™
Model Number 472005
Connectors F-Female
Antenna Impedance 50 Ohms
Frequency 824-894 MHz / 1850-1990 MHz
Passband Gain (nominal)
800 MHz
Band 5
60.3
1900 MHz
Band 2
60.4
20 dB Bandwidth (MHz)
800 MHz
Band 5
1900 MHz
Band 2
Typical
Maximum
40.8
41.1
74.7
75.0
Power output for single cell phone (dBm)
800 MHz
Band 5
1900 MHz
Band 2
Uplink
Downlink
24.9
-2.2
22.5
-2.1
Power output for multiple received channels
(Uplink) dBm
No. Tones
800 MHz
Band 5
1900 MHz
Band 2
2 24.8 20.2
3 21.3 16.7
4 18.8 14.2
5 16.9 12.3
6 15.3 10.7
Power output for multiple received channels
(Downlink) dBm
No. Tones
800 MHz
Band 5
1900 MHz
Band 2
2 1.3 3.5
3 -2.2 -0.1
4 -4.7 -2.6
5 -6.6 -4.5
6 -8.2 -6.1
Noise Figure (typical downlink/uplink) 3 dB nominal / 6 dB nominal
Isolation > 90 dB
Power Requirements AC / DC 6V, 2.5A, w/2.5x5.5mm Jack
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present, the
rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users. This
power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The
Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for ve minutes, it
will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power
off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (ve) such automatic restarts, any problematic
bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained
by the Signal Booster’s microprocessor.