Installation Guide ® Drive Reach RV Cell Signal Booster Use our weBoost App to guide you through the installation. See inside page for more details.
Download the weBoost App Download the weBoost App Use our app to guide you through setting up a weBoost cell phone signal booster in your home, business, or vehicle. Boost every network, including 5G, positioning right away.
Index Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 STEP 1 Mount Outside Antenna & Route Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 STEP 2 Connect Cable to Outside Antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 STEP 3 Inside Antenna Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Package Contents Drive Reach Signal Booster & Bracket 1 Outside Antenna & 25' RG-6 Cable Inside Antenna Power Supply 13 in.
STEP 1 Mount Outside Antenna & Route Cable common Outside Antenna location Determine where you want the outside antenna on your RV. Mount outside antenna to a ladder or pole so that the entire outside antenna is above the roof line of the RV and clear of other metal obstructions. Important NOTE: Keep in mind to stay below the maximum height limit allowed by law, which varies from state to state (generally 14 ft. in western states and 13 ft.6 in. in eastern states).
(STEP 1 cont.) To assemble the outside antenna, insert cable through mast extension then through side exit adapter. NOTE: Antenna spring can be used optionally. 13 in. mast cable from Outside Antenna 13 in.
(STEP 1 cont.) Verify the outside antenna is the correct height, if so, use thread locker (provided) to thread points and screw into place. NOTE: When adding the side exit adapter hold the outside antenna vertically and screw the side exit adapter from the bottom up. This reduces cable twisting.
(STEP 1 cont.) Mount outside antenna. L-bracket mount and hardware is provided to mount to ladder or pole. If installing with spring, the side exit adapter must be used. Then route 25’ RG-6 cable from inside RV to outside antenna. NOTE: Outside antenna location must be within reach of the booster with the 25’ coax cable. The system performs best with maximum vertical and horizontal separation.
STEP 2 Connect Cable to Outside Antenna Cable from Outside Antenna After routing the RG-6 cable into the RV, connect the cable to the outside antenna. RG-6 Cable STEP 3 Inside Antenna Location & Connect Cable Inside Antenna Place inside antenna where stronger signal is desired in the RV.
STEP 4 Booster Location & Connect Cables from Outside Antenna Find a location to place the Drive Reach booster and secure it with provided bracket. Connect cable from outside antenna to labeled booster port and connect cable from inside antenna to labeled booster port. from Inside Antenna STEP 5 Connect Power Supply to Booster Connect the power supply cord to the end of the booster, labeled “12V DC”, and connect into a 12V wall plug.
Booster Light Patterns SOLID GREEN This indicates that your Drive Reach booster is functioning properly and there are no issues with installation. SOLID RED Band has shutoff. This is due to a feedback loop condition called oscillation. This is a built in safety feature that causes a band to shut off to prevent harmful interference with a nearby cell tower. Refer to Troubleshooting section.
(Booster Light Patterns cont.) NOTE: The signal booster can be reset by disconnecting and reconnecting the power supply. After troubleshooting you must initiate a new power cycle by disconnecting and then reconnecting power to the booster.
Troubleshooting FIXING BLINKING OR RED LIGHT ISSUES This section is only applicable if the booster is red or blinking red and you are not experiencing the desired signal boost. 1 Unplug the booster’s power supply. 2 R elocate the inside and outside antenna further from each other. The objective is to increase the separation distance between them, so that they will not create this feedback condition discussed before. 3 Plug power supply back in. 4 M onitor the indicator light on your booster.
(Troubleshooting cont.) FREQUENTLY ASKED QUESTIONS How can I contact customer support? Customer Support can be reached Monday thru Friday by calling 1-866-294-1660, or through our support site at support.weboost.com. Why do I need to create distance between the booster and the antenna? Antennas connected to a booster create spheres of signal. When these spheres overlap, a condition called oscillation occurs.
Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost product may damage your equipment. Connecting this signal booster directly to the cell phone with use of an adapter will damage the cell phone. RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons. AWS Warning: The outside antenna must be installed no higher than 10 meters (31’9”) above ground. This is a CONSUMER device.
(Safety Guidelines cont.) FOR MORE INFORMATION ON REQUIREMENTS SET OUT IN ISED CPC-2-1-05, SEE BELOW: http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08942.html FOR MORE INFORMATION ON REGISTERING YOUR SIGNAL BOOSTER WITH YOUR WIRELESS PROVIDER, PLEASE SEE BELOW: T-Mobile/Sprint/MetroPCS: https://www.t-mobile.com/support/coverage/register-a-signal-booster Verizon Wireless: http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html AT&T: https://securec45.securewebsession.com/attsignalbooster.
Antenna Info The following accessories are certified by the FCC to be used with the Drive Reach Booster. This radio transmitter 4726A-460061 has been approved by innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Specifications Drive Reach Cell Signal Booster 460061 Model PWO460061 FCC 4726A-460061 IC SMA-Female Connectors 50 Ohms Antenna Impedence Frequency 698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz Power output for single cell phone (Uplink) dBm 700 MHz B12/17 25.4 700 MHz B13 25.6 Power output for single cell phone (Downlink) dBm 4.8 4.8 Noise Figure 800 MHz B5 25.6 1700 MHz B4 26.7 1900 MHz B2 26.9 4.8 4.6 4.
2 YEAR WARRANTY weBoost Signal Boosters are warranted for two (2) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weBoost. weBoost shall, at its option, either repair or replace the product.
3301 East Deseret Drive, St. George, UT 1.866.294.1660 www.weboost.com support@weboost.com Copyright © 2020 weBoost. All rights reserved. weBoost products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA GDE000471_Rev01_02.22.
