A WILSON ELECTRONICS BRAND Office 200 Cell Signal Booster Office 200 Installation Guide NEED HELP? support.weboost.com 866.294.
______ Index Package Contents 1 Preparation 3 STEP 1: Inside Antenna & Booster Placement 5 STEP 2: Mount Outside Antenna 6 STEP 3: Route & Connect Outside Antenna To Booster 7 STEP 4: Route & Connect Inside Antenna To Booster 8 STEP 5: Power Up The Booster 9 Measuring Booster Performance 10 Menu System 12 Troubleshooting 16 Safety Guidelines 17 Specifications 19 Warranty 20
______ Package Contents Office 200 50 Ohm Kit Office 200 Booster Power Supply (850026) Inside Antenna (314407) Outside Antenna (314422) Lightning Surge Protector (859902) 75’ & 60’ Wilson 400 Cables (952360 & 952375) 2’ Wilson 400 Cable (952302) Cable Mounting Clips Office 200 75 Ohm Kit Office 200 Booster Power Supply (850026) OFFICE 200 Inside Antenna & Connector (314407) Outside Antenna (314423) Lightning Surge Protector (859992) 75’ & 60’ RG-11 Cables (951160 & 951175) 2’ RG-11 Cable (9
______ Key Features Extended Dynamic Range (XDR) for continuous connectivity: XDR lets the Office 200 system work with any incoming signal and never shuts down due to a strong outside signal. Simple Wall-Mount Installation: An indoor and outdoor port are located on top of the amplifier for easy antenna connections, while an exposed mounting flange at each corner of the amplifier provides for simple and clean wallmount installation.
______ Preparation You Will Need (tools not included) Make sure the following materials are prepared and ready for your installation.
______ Installation Diagram 60 FEET HORIZONTAL OR 25 FEET VERTICAL DISTANCE Troubleshooting section recommends increasing distance further if needed.
______ Step 1: Inside Antenna & Booster Placement Place the inside antenna in the ceiling over where you need the greatest signal boost and place booster in your desired location at least 24” away from inside antenna. NOTE: Do not connect booster to power until the system is fully installed.
______ Step 2: Mount Outside Antenna Pole mounting and wall mounting options are included. Attach the mount to the outside antenna and use the bracket clamp to attach the antenna to a pole or exhaust pipe. Outside Antenna L-Bracket U-Bolt Pole Bracket existing pole NOTE: Mounting on existing roof exhaust pipe would be a good time-saver option. Watch out for power lines.
______ Step 3: Route & Connect Outside Antenna To Booster Connect 2 ft. coax cable to outside antenna, attach the lightning surge protector, then connect the black 75 ft. coax cable and route into building. Cable Mounting Clips provided Lightning Surge Protector 75’ Coax Cable Outside Antenna 2’ Coax Cable Booster Route cable to the Office 200 booster and connect to the port labeled ‘OUTSIDE ANTENNA’.
______ Step 4: Route & Connect Inside Antenna To Booster Connect the black 60 ft. coax cable to inside antenna and route to the Office 200 booster and connect to the port labeled ‘INSIDE ANTENNA’.
______ Step 5: Power Up The Booster Plug the power supply into wall outlet then connect to end of booster labeled “ ” and enjoy your boosted signal. NOTE: We strongly recommend using a power strip with surge protection. Office 200 to power 60 FEET HORIZONTAL OR 25 FEET VERTICAL DISTANCE Troubleshooting section recommends increasing distance further if needed.
______ Measuring Booster Performance How To Get Signal Strength As A Number iPhone® iOS 11 and later no longer displays the decibel (dBm) reading in ‘Field Test Mode’. Tip: Using the signal bars and performing data speed tests on your cell phone can assist you in finding the strongest signal direction as well as placing calls in different locations. For changes/updates on this issue, periodically go to weboost.com/signalstrength.
______ (MEASURING BOOSTER PERFORMANCE cont.) Signal Strength without Booster Note here: Signal Strength with Booster Note here: Compare Results Having an accurate measurement of signal strength in decibel-milliwatts (dBm) is crucial when installing your system. dBm accurately measure the signal strength you are receiving.
______ Menu System The Office 200 takes about 5 seconds to boot up. Once boot up is complete, the home screen will appear, showing the amplification and status of each port and band. Home Screen Start Up Screen Band Menu Color Desrciption GREEN: A solid green light indicates that a band is operating correctly with maximum allowable gain. YELLOW: A solid yellow light indicates band gain reduction because of an oscillation condition.
Settings Screen Tap icon to view the Settings Screen. Bands can be disabled/enabled by tapping the desired band. Note: disabling a cell band is not recommended. Bands should only be disabled by expert installers.
To go back to the home screen tap on the home icon. To view specific band information (such as the strength of the received uplink & downlink signal, status details and the amplifier gain) tap desired band on the home screen.
By tapping on the desired Band, a more detailed screen will appear for better troubleshooting. Note: If the reduced gain due to oscillation is greater or equal to 60dB, this condition will be displayed as Green instead of Yellow and no action is necessary.
______ Troubleshooting IF YOU ARE HAPPY WITH THE COVERAGE, THESE LIGHT ISSUES DON’T HAVE TO BE RESOLVED. YOUR CARRIER’S BAND HAS NOT BEEN AFFECTED. If the bands are any color other than green, use the touchscreen LCD and tap any given band that’s not green to see troubleshooting options. NEED HELP? 16 support.weboost.com CELL PHONE SIGNAL BOOSTER 866.294.
______ Safety Guidelines Use only the power supply provided in this package. Use of a non-weBoost power supply may damage your equipment. The signal booster unit is designed for use in an indoor, temperature-controlled environment (less than 100 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to temperatures in excess of that range. RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons.
______ Antenna Kit Options The following accessories are certified by the FCC to be used with the Office 200 Booster. Outside antenna maximum permissible antenna gain (dBi) 50Ω Inside antenna maximum permissible antenna gain (dBi) 50Ω BAND 12/17 BAND 13 BAND 5 BAND 4 BAND 25/2 4.5 4.2 4.5 4.4 4.7 -0.4 -0.1 -0.7 2.4 1.
______ Specifications Office 200™ Model Number 460047 FCC ID PWO460047 Connectors N-Female / F-Female Antenna Impedance 50 Ohms / 75 Ohms Frequency 698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz Power output for single cell phone (Uplink) dBm Power output for single cell phone (Downlink) dBm Noise Figure Isolation 700MHz Band12/17 700MHz Band13 800MHz Band 5 1700MHz Band 4 24.0 24.0 25.0 25.
3 YEAR WARRANTY weBoost Signal Boosters are warranted for three (3) years against defects in workmanship and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with a dated proof of purchase. Signal Boosters may also be returned directly to the manufacturer at the consumer’s expense, with a dated proof of purchase and a Returned Material Authorization (RMA) number supplied by weBoost. weBoost shall, at its option, either repair or replace the product.
3301 East Deseret Drive, St. George, UT 866.294.1660 www.weboost.com support.weboost.com Copyright © 2021 weBoost. All rights reserved. weBoost products covered by U.S. patent(s) and pending application(s) For patents go to: weboost.com/us/patents NOT AFFILIATED WITH WILSON ANTENNA GDE000415_Rev01_05.20.
Office 200 SKU: 50 Ohm: 472047 75 Ohm: 471047 MAP: $1,699.99 FEATURES • Ideal amplifier system for small-to-medium businesses • Covers 12,000 to 35,000 square feet • Comes with LCD touch screen for increased usability • Allows manual control of frequency bands • Is FCC approved and works on all U.S.
How It Works Package Dimensions 1 Outside antenna: The outside antenna communicates back and forth with nearby cell towers. 2 Booster: The booster amplifies any cell signals it receives from the outside antenna. 3 Inside antenna: The inside antenna broadcasts these signals for use throughout your business. Support 19 L x 13 W x 13 H 3-Year Warranty from Purchase. 19 in. x 13 in. 13 in. x 13 in. 19 in. x 13 in. FRONT SIDE TOP/BOTTOM MASTER CARTON: 19 L x 13 W x 13 H | 22 Lbs. 22.00 lbs.
