User's Manual

11
Trim Adjustment & Countering Drift
Even after a craft is calibrated, it may still drift while airborne. To counter this effect you can
adjust the trim for better control. However, adjusting the trim may not entirely eliminate
drifting. Air currents and other factors can still affect the craft’s handling in the air.
Making Trim Adjustments
Press and hold the Trim button to enter Trimming Mode, indicated by an audible chime from
the remote. While in Trimming Mode, move the Right Control Stick ONCE in the opposite
direction of the drift. Each adjustment will be indicated by a single chime from the remote.
When you are finished, press and hold the Trim button to exit Trimming Mode.
As an example, if the craft is drifting forward, pull rearward on the stick to correct. If the
craft is drifting right, pull left. The remote will chime once for each adjustment. It may take
multiple adjustments to set the trim to your liking.
To avoid potential damage, adjust the trim while attempting a stable hover and adjust one
trim setting at a time to avoid confusion.
Note: While in Trimming Mode, the Right Control Stick only makes trim adjustments
and does not control the direction of the craft. You must exit Trimming Mode to resume
normal flight controls. The Left Control Stick is not affected by Trimming Mode.
RESET HEADLESS TRIM
ON
OFF
Press and hold to enter
and exit Trimming Mode.
Move Right
Control Stick
to adjust Pitch
and Roll trim.
Remote will chime
once for each
adjustment.