User's Manual

20
Troubleshooting
If you are experiencing problems using or ying the hexacopter, consult this table.
PROBLEM POSSIBLE CAUSES SOLUTION
Craft is unresponsive
• No power to remote
or craft
• Poor contact between
power plugs
• Craft is out of receiver
range
• Check remote batteries,
replace if needed
• Check craft’s battery, be
sure it is fully charged
• Be sure the power
plugs are rmly
connected
• Be sure the remote has
an unobstructed line of
sight to the craft
• Remain within the
remote’s 150 ft. range
Craft ies erratically
• Gyroscopes may
be misaligned
• Recalibrate gyroscopes
(see next page)
• Perform Pre-Flight
Calibration again
(see pg. 13)
• Perform factory reset
(see next page)
Craft drifts
while in ight
• Trim not set or needs
adjustment
• Adjust trim settings
(see pg. 15)
Craft suffers from
mechanical
difculty or
vibrates excessively
• Damage to body,
rotors, or other major
components
• Check to make sure
the craft has not taken
signicant damage
• Replacement parts
may be needed
(see pg. 22)
Formation lights ON,
but craft no
longer responds to
throttle inputs
• Low battery power • Recharge the battery