User's Manual

operation. Note: This equipment has been tested and found to comply with the limits for a

1. Check to see if transmitter and car are on.

2. Replace batteries.

1. Check if the servo feels jammed, try centering it by hand.

2. Check the whole steering system.

1. Check gear mesh between spur gear and pinion.

2. Check for stripped and/or dirty gears.

3. Clean and oil bushings or ball bearing.

1. Check if there are damaged parts.

2. Replace or charge the battery pack and/or the radio batteries.

3. Check if there are damaged parts.

A. The vehicle does

not work at all.

B. The vehicle runs

slow.

C. The throttle works,

but not the steering.

D. It steers, but throttle

is uncontrollable.

E. The vehicle runs

nosily.

1. Replace or charge the battery pack and/or the radio batteries.

2. Make sure the vehicle is geared properly and pinion and spur

gear are over tightened.

3. Clean all bushings or ball bearings.

4. Check for stripped or dirty gears.

TROUBLESHOOTING PRECAUTIONS AND CARE

FCC STATEMENT

This device com

plies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonble protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no quarantee

that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help.

warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.