Hedge Trimmer Operator's Manual

4
ASSEMBLY
CARTON CONTENTS
Hedge Trimmer
Assist Handle
Screw
Nut
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find parts
missing or damaged, call 1-800-554-6723.
If you receive your unit assembled, check
each step to be sure your unit is properly
assembled. Follow all safety information in
the manual and on unit.
ASSIST HANDLE ATTACHMENT
WARNING: Do not use without the as-
sist handle properly installed.
This unit is equipped with an assist handle
for extra comfort and control.
S
Place the assist handle on the unit.
Assist Handle
S
Insert screw through assist handle and
motor housing.
Screw
Nut
S
Thread nut onto scr ew. Tighten securely.
OPERATION
Use only the voltage supply specified on your
unit. See chart below to select the proper ex-
tension cord.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
100 ft.
16 gauge
50 ft.25 ft.
16 gauge 16 gauge
Extension cords are available for this unit.
Recessed
Plug
Cord
Receptacle
Cord Retainer
Hook
DOUBLE INSULATION CONSTRUCTION
This unit is Double Insulated to help pro -
tect against electric shock. Doubleinsula-
tion construction consists of two separate
“layers” of electrical insulation instead of
grounding.
Tools and appliances built with a double in-
sulation system are not intended to be
grounded. No grounding means is provided
on this unit, nor should a means of ground-
ing be added to this unit. As a result, the ex-
tension cord used with your unit can be
plugged into any standard 120 volt electri-
cal outlet.
Safety precautions must be observed
when operating any electrical tool. A
double insulation system only provides
added protection against injury resulting
from internal electrical insulation failure.
W ARNING:
All electrical repairs to this
unit, including housing, switch, motor , etc.,
must be diagnosed and repaired by quali-
fied service personnel. Replacement parts
for a double insulated appliance must be
identical to the parts they replace. A double
insulated appliance is marked with the
words
DOUBLE INSULA TION
or
DOUBLE IN-
SUL ATED
. The symbol (square within a
square) may also be marked on the ap-
pliance. Failure to have the unit repaired by
qualified service personnel can cause the
double insulation construction to become
ineffective and result in se rious injury.
CORRECT OPERATING POSITION
Stand as shown; check for the following:
S
Operator wearing safety glasses/eye
protection and proper clothing.
S
Right hand holding rear handle, left hand
holding assist handle.
S
Unit below waist level.