Blower Instruction Manual

6
4. To attach the lower vacuum tube to
the upper vacuum tube, first align the
arrows on the two tubes. Then, press
the two tubes together until the lower
tube is securely seated in the upper
tube (about 3 inches).
Align arrows on upper
and lower tubes
Lower TubeUpper Tube
COLLECTION BAG ASSEMBLY
1. Open the zipper on the collection
bag and insert the e lbow tube.
2. Push the small end of the elbow tube
through the small o pening in the bag.
NOTE: Make sure edge of the small
opening is flush against the flared area
of the elbow tube and the hole for the
tube release button is on top.
Small
Opening
Zipper
Opening
Elbow Tube
Tube
Release
Button
Hole
3. Close the zipper on the bag. Make
sure the zipper is closed completely.
4. Align the grooves on the elbow tube
with the grooves on the blower outlet.
5. Push the elbow tube onto the blower
outlet until it snaps into place (elbow
tube is secured by red tube release
button).
ADJUSTING THE SHOULDERSTRAP
ON THE COLLECTION BAG
1. Carefully loop the shoulder strap
through the buckle as shown in the il-
lustration below.
First In
Last In
2. Position the unit on your right-hand
side, blower outlet and bag pointing
toward the rear. Hold the unit in an
upright position with the lower vacu-
um tube on the ground to support it.
3. Place the shou lder s trap over your
head and onto your left sh oulder.
4. Adjust the strap to allow a free flow of
air from the blower. If the collection
bag is kinked, the unit will not operate
properly.
NOTE: The strap is desi g ned to posi-
tion the col l e cti on bag on your should er
wit hout kinks. The strap is not intended
to support the wei ght of the unit.
Shoulder strap
on left shoulder
No kinks in bag
allows free air flow
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Stop unit and unplug the exte ns i o n
cord.
2. Remove the vacuum tubes by inse rt-
ing the tip of a screwdri ver into the
latch area on the vacuum assi st han-
dle. Gently t i l t handle of screwdri ver
towar d the front of the unit to release
the latch while pulling up on the vacu-
um assist handle with your other hand.
Latch Area
Vacuum
Assist
Handle
3. Install the inlet restrictor that was re-
moved when assembling for vacuum
use.
NOTE: If you are un able to locate the
inlet restrictor, the unit will still operate.
This restrictor improves the blower
function.
4. Remove the collection bag.
5. Close the inlet c over and make s ure
it is latched closed.
6. Re-install the blower tube. Refer to
AT-
TACHING THE BLOWER TUBE
for
instr ucti ons on how to attach t hi s it e m .
SELECT AN EXTENSION CORD
Use only a 12 0 A.C. voltage supply as
shown on nameplate of the unit to
power y our blower.