- Wegener Unity RF Switch Installation and Operation Guide

ManualsBrandsWegener Communications ManualsSwitchUnity RF Switch

Installation/Operation Guide

UNITY RF Switch Option

Data, drawings, and other material

contained herein are proprietary to

Wegener Communications, Inc., and

may not be reproduced or duplicated in

any form without the prior permission

of Wegener Communications, Inc.

When ordering parts from Wegener

Communications, Inc., be sure to include

the equipment model number, equipment

serial number, and a description of the part.

In all correspondence with Wegener

Communications, Inc., regarding this

publication, please refer to Manual Number

800016-13 A.

First Edition: August 2000

WEGENER

TECHNOLOGY PARK/JOHNS CREEK

11350 TECHNOLOGY CIRCLE

DULUTH, GEORGIA 30097-1502

(770) 814-4000 FAX (770) 623-0698

COMMUNICATIONS

Summary of content (6 pages)

PAGE 1
Installation/Operation Guide UNITY RF Switch Option Data, drawings, and other material contained herein are proprietary to Wegener Communications, Inc., and may not be reproduced or duplicated in any form without the prior permission of Wegener Communications, Inc. When ordering parts from Wegener Communications, Inc., be sure to include the equipment model number, equipment serial number, and a description of the part. In all correspondence with Wegener Communications, Inc.
PAGE 2
Page 2 1. INTRODUCTION The UNITY RF Switch is a software-controlled, four-input, single-output, L-band switch. It allows network and local control of antenna feed selection as well as other signal parameters. Please read the entire set of instructions before beginning the installation. 2.
PAGE 3
Page 3 B. INSTALL THE RF SWITCH See Figure 1 (Page 5) and Figure 2 (Page 5) of this guide for views of the module and its installation. 1. Remove the block-out plate from the Module where the switch is to be installed. These screws and holes will be used to mount the RF Switch in a later step. Use the #1 Philips Screwdriver for this. 2. From the inside of the unit, install the RF Switch into position. The “F” Connectors should protrude through the rear panel 3.
PAGE 4
Page 4 C. SET RF SWITCH OPTIONS 1. Set Jumpers on the option card to the dotted position. When setting the jumpers, observe that there are three pins on each header. The jumper covers two of these pins and connects them together electrically. In one position Pin 2 (center pin) is connected to Pin 1, while in the other position Pin 2 is connected to Pin 3. Changing the jumpers changes the configuration of the circuit board and how the board operates.
PAGE 5
Page 5 RF Signal In x 4 Cable from RF Switch Out to Tuner In screws from blockout plate Rear Module 1 Tuner Mounting Bracket Hole Used If Mounted In Module 1 Tuner Board Hole used if Mounted in Module 2 1 0 UNITY4000 MOTHER BOARD 2 J 1 1 J1 P/S STANDOFFS 3 in each Module area Red Line RF Switch Expansion 1 Front Figure 1.
PAGE 6
Page 6 SERVICE RETURN ADDRESS Service Department RMA# ________ Wegener Communications, Inc. 359 Curie Drive Alpharetta, GA 30005 SERVICE CONTACT NUMBERS AND ADDRESSES Voice: (770) 814-4057 FAX: (678) 624-0294 email: service@wegener.