User`s manual

Operation
38 800032-01 Rev. G www.wegener.com
tone: Tone code (0-15 signifying digits 1-9,0,*,#,A-C).
Volatile test command for DTMF output, if supplied. Tones will be output at the percentage of full-scale
voltage indicated by level. If tone is supplied, then that tone is output continuously. If tone is
omitted, then the IRD cycles endlessly through all tones, 1 second per tone. Disable with
TESTOFF command. A Local Control Command (available from the terminal regardless of
"Local Control Enable/Disable" commands from the network).
DTMFVOL percent
percent: Integer between 0 and 100 inclusive.
Command to set DTMF output tone levels. Immediately after entry of the command, the IRD will play out
all 16 tones (at a rate where they are individually identifiable) at the commanded level. If
percent is ‘0’, output is essentially OFF. If percent is ‘100’, level is maximum spec level.
Entering command without parameters still plays out the tone sequence and then reports
current level setting. A Local Control Command (available from the terminal regardless of
"Local Control Enable/Disable" commands from the network).
EMAIL x
x: Either E for Enabled, or D for Disabled.
Command to enable COMPEL
®
printed email. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
ERRORS type threshold
type: Either E for Error’d Seconds or C for Continuity-count errors.
threshold: Integer between
1 and 255.
Command to set either Error’d-seconds-rate or Continuity-count Alarm threshold. Unit will show an alarm
if, over any previous 60 second interval, the number of type events which are detected
exceeds threshold. A Local Control Command (available from the terminal regardless of
"Local Control Enable/Disable" commands from the network).
EXIT
Command ends telnet sessions. Same as QUIT command.
FORCERF port
port: Either OFF or the numbers 1, 2, 3, or 4.
Command to either disable or enable effective RF switch bypassing. If port is a number, then all
subsequent carrier reception is sought at that RF feed port, regardless of the current Unit
Setting. If port is
OFF, then normal RF switch function is restored. Entering the command
without parameters gives current status, either
Normal RF Switch, or Forced RF Feed Port n
where n is either
1, 2, 3, or 4. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
GHOSTLIST action PID
action: A for Add or D for Delete.