User Manual

A. The clearance between the release lever and the release shaft should be 3mm.
The diesel engine takes out power through flywheel, supporting disc, pressure disc
and driven plate putout shaft. A flat belt pulley, V - belt pulley or a coupler can be
installed at the output shaft end.
The front end of the clutch output shaft is supported on the' flywheel bearing, the
rear end
is supported on the two bearings inside the clutch housing. The release
bearing
and the seat are installed on the front bearing cover. There are three pulling
ears
on the pressure disc stretched out of the supporting disc, on which installed
three release lever. When the control lever
is moved forward, the release yoke pu-
shes the release bearing move forward, the release bearing contacts the release le-
ver, and press the lever to overcome the pressure of the spring and leave the driven
plate, finally cut the power.
12. The Main Changed Parts of K4100 Diesel Engine
K4100 diesel engine is developed on the basis of 495 through cylinder expansion.
The cylinder block, cylinder liner, water seal ring, cylinder cover gasket, piston and
piston ring are newly designed. They can be in common use with 495 diesel engine.
13. The 'Main Changed Parts of ZH4100 Diesel Engine
ZHlI00 diesel engine is developed on the basis of K4100 by the changing of direct in-
jection. The main changed parts are cylinder head, fuel pump, injector, high pres-
sure pipe, inlet pipe
,piston and piston ring etc.
•
43 •