Instructions / Assembly

9
10. Orient the Backrest Frame (5) so that the pivot
tube is in the location shown. Make sure that
there is a Backrest Frame Bushing (28) in
each side of the pivot tube. If necessary, press
a Backrest Frame Bushing into each side of the
pivot tube.
Attach the Pivot Bracket (7) to the Backrest
Frame (5) with two M8 x 80mm Bolts (43) and
two M8 Locknuts (17); do not tighten the
Locknuts yet.
9. Attach the tether on the Locking Pin (36) to the
Seat Frame (2) with an M4 x 19mm Screw (22).
9
10
2
36
43
17
28
28
7
5
Pivot
Tube
22
11
40
36
7
49
2
Grease
11. Apply a small amount of grease to an
M12 x 88mm Bolt (40).
Insert the Pivot Bracket (7) into the slot in the
Seat Frame (2).
Next, attach the Backrest Frame (5) to the
bracket on the Seat Frame (2) with the
M12 x 88mm Bolt (40) and an M12 Locknut (49).
Do not overtighten the Locknut; the Backrest
Frame must pivot easily.
Then, insert the Locking Pin (36) through the
Seat Frame (2) and into one of the adjustment
holes in the Pivot Bracket (7).
See step 10. Tighten the M8 Locknuts (17).
5