Instructions / Assembly

3. Orient the Backrest Frame (3) so that the welded

tubes (A) are in the position shown. In addition,

orient the Backrest Bracket (5) as shown.

Attach the Backrest Bracket (5) to the Backrest

Frame (3) with four M8 x 15mm Screws (13) and

four M8 Washers (18); do not fully tighten the

Screws yet.

4. Insert the end of the Backrest Bracket (5) into

the Frame (1), and then attach the Backrest

Frame (3) to the Frame with an M12 x 100mm

Bolt (14), two M12 Washers (15), and an M12

Locknut (16) as shown. Do not overtighten

the Locknut; the Backrest Frame must pivot

freely.

See step 3. Tighten the M8 x 15mm Screws (13).

See the inset drawing. Firmly tighten one of

the Adjustment Knobs (9) into the Frame (1) and

into one of the adjustment holes in the Backrest

Bracket (5). Then, tighten one of the Stop Screws

(17) into the end of the Backrest Bracket.