Owner's Manual

7
3. Attach the Olympic Adapter (22) to the Weight
Tube (6) with an M8 x 10mm Set Screw (99).
Attach the Weight Tube (6) inside the Leg Lever
(4) with an M8 x 60mm Bolt (91), two M8
Washers (84), a 13mm x 13mm Spacer (78),
and an M8 Nylon Locknut (81). Next, press the
25mm Round Angled Cap (19) onto the Weight
Tube; make sure the widest part of the
Round Angled Cap is at the bottom.
Apply grease to an M10 x 68mm Bolt (85).
Attach the Leg Lever (4) to the Front Leg (3)
with the Bolt and an M10 Nylon Locknut (80).
Do not overtighten the Nylon Locknut; the
Leg Lever must pivot easily.
4. Orient the two Backrest Frames (9) so the indi-
cated holes are closer to the bottom. Attach the
Backrest Frames to the Backrest Bracket (7)
with four M10 x 48mm Bolts (92), four M10
Washers (83), and four M10 Nylon Locknuts
(80). Do not tighten the Nylon Locknuts yet.
5. Attach the Bench Backrest (11) to the Backrest
Frames (9) with four M6 x 40mm Screws (100)
and four M6 Washers (96). Do not tighten the
Screws yet.
85
80
3
Grease
6
19
78
81
22
99
84
84
91
4
3
4
Holes
9
80
7
83
92
92
83
83
80
5
96
96
11
96
100
100
9