Owner's Manual

10
14. Attach the Top Frame (16) to the Center Top
Frame (14) with two M10 x 116mm Button Bolts
(
101), four M10 Washers (84), and two M10
Nylon Locknuts (79).
Do not tighten the
L
ocknuts.
Attach the Top Frame (16) to the Butterfly Frame
(12) and the Backrest Upright (8) with four M10 x
67mm Button Bolts (90), four M10 Washers (84),
and four M10 Nylon Locknuts (79). Do not tight-
en the Locknuts.
Attach the Top Frame (16) to the Carriage Guides
(64) with two M10 x 93mm Button Bolts (97), four
M10 Washers (84), four 25mm Spacers (55), and
two M10 Nylon Locknuts (79).
Do not tighten the
Locknuts.
16. The following steps are shown from the rear
of the weight rack. During steps 16–45, refer
to the CABLE DIAGRAMS on pages 24 and 25
to identify cables and ensure proper cable
routing.
Identify the Butterfly Cable (71).
Attach the Cable
to the Right Arm (11) with an M8 x 19mm
Shoulder Bolt (85) and an M8 Nylon Locknut (78).
Make sure that the Cable can pivot easily on
the Bolt.
15. Attach the Foot Plate (9) to the Center Base (2)
and the Backrest Upright (8) with four M10 x
19mm Button Bolts (77) and four M10 Nylon
Locknuts (79).
Tighten the bolts, screws, and locknuts used
in steps 2–12 and 14–15.
17. Route the Butterfly Cable (71) over a “V”-pulley
(60). Attach the “V”-pulley, a Large Cable Trap
(61), an M10 Washer (84), and two Full Finger
Guards (39) to the Backrest Upright (8) with an
M10 x 62mm Button Bolt (88) and an M10 Nylon
Locknut (79). Make sure that the Cable T
rap is
turned to hold the Cable in the groove of the
“V”-pulley
.
101
8
4
9
0
84
1
6
14
14
84
85
16
15
17
71
11
88
61
60
84
79
8
78
79
77
79
79
9
2
8
77
79
12
84
84
79
55
55
64
97
8
79
39
71
39