Owner's Manual

9
10. Orient the Center Top Frame (14) with the decal
in the position shown. Make sure that the Rod
C
ap (33) is inside of the left Side Top Frame (13).
A
ttach the Center Top Frame (14) to the Side Top
Frame (13) with two M10 x 93mm Button Bolts
(97), two 17mm Spacers (66), two M10 Washers
(84), and two M10 Nylon Locknuts (79). Do not
tighten the Locknuts.
Repeat this step with the right Side Top Frame
(not shown).
12. Attach the Butterfly Frame (12) to the Backrest
Upright (8) with two M10 x 67mm Button Bolts
(90), two M10 Washers (84), and two M10 Nylon
Locknuts (79). Do not tighten the Locknuts.
13. Grease an M10 x 85mm Button Bolt (144) and
the two Arm Bushings (31) in the Left Arm (10).
Attach the Left Arm to the Butterfly Frame (12)
with the Bolt and an M10 Nylon Locknut (79).
Do
not overtighten the Locknut; the Left Arm
must be able to pivot easily.
Repeat this step with the Right Arm (11).
11. Attach a Support Frame (15) to the left Side Top
Frame (13) with two M10 x 93mm Button Bolts
(97), two M10 Washers (84), and two M10 Nylon
Locknuts (79).
Do not tighten the Locknuts.
Attach the other Support Frame (15) to the
right Side Top Frame (13) in the same manner.
Attach the two Support Frames (15) to the
Backrest Upright (8) with two M10 x 95mm Button
Bolts (92) and two M10 Nylon Locknuts (79). Do
not tighten the Locknuts.
9
7
14
13
33
66
79
84
97
Decal
10
11
66
13
13
15
15
97
97
79
79
92
8
92
8
79
84
12
79
84
84
90
90
12
13
144
79
10
11
12
31
31
Grease
Grease