Owner's Manual

10
11
17
22
46
46
3
21
15
55
96
58
Ball
Hook
13
12
14
CABLE ASSEMBLY
58
21
50
31
86
42
86
48
50
31
47
21
58
55
During steps 12 to 26, refer to the CABLE DIA-
GRAM on page 21 of this manual. Identify the
three cables by their lengths, and note the posi-
tions of the cable traps. IMPORTANT: Do not over-
tighten the bolts and nuts securing the pulleys.
The pulleys must turn freely.
12. Locate the Medium Cable (58). Route the
Medium Cable over an 90mm Pulley (15). Attach
the Pulley to the Top Frame (55) with an M10 x
90mm Bolt (96) and an M10 Nylon Locknut (21).
Make sure that the ball is on the indicated
side of the Pulley and that the Cable is
between the Pulley and the hook.
13. Wrap the Medium Cable (58) around a “V”-pulley
(50).
Attach the “V”-pulley and a Long Cable Trap
(31) to the indicated bracket on the Front Upright
(42) with an M10 x 60mm Bolt (86) and an M10
Nylon Locknut (21). Make sure that the Long
Cable Trap is positioned to hold the Cable in
place.
14. Route the Medium Cable (58) around a “V”-pulley
(50). Attach the “V”-pulley and a Long Cable Trap
(31) to the Left Arm (47) with an M10 x 60mm
Bolt (86) and an M10 Nylon Locknut (21).
Make
sure that the Cable is in the groove of the
Pulley and that the Cable Trap holds the Cable
in place.
Route the Medium Cable (58) under the Top
Frame (55) and repeat this step with the Right
Arm (48).
11. Attach the Press Arm (46) to one side of the
Press Frame (17) with two M8 x 62mm Bolts (22)
a
nd two M8 Nylon Locknuts (3).
A
ssemble the other Press Arm (46) in the
same manner.