Owner's Manual

11
15. Route the Medium Cable (58) over a 90mm
Pulley (15). Attach the Pulley and a Cable Trap
(66) to the Pulley Bracket (20) with an M10 x
45mm Bolt (12) and an M10 Nylon Locknut (21).
Make sure that the Cable is in the groove of
the Pulley and that the Cable Trap holds the
Cable in place.
Attach the Pulley Bracket (20) to the Top Frame
(55) with an M8 x 118mm Bolt (68) and an M8
Nylon Locknut (3). Do not over tighten the
Locknut; the Pulley Bracket must be able to
pivot freely.
16. Wrap the Medium Cable (58) under a 90mm
Pulley (15). Attach the Pulley and a Cable Trap
(66) to the upper hole inside the Long “U”-bracket
(57) with an M10 x 48mm Bolt (94) and an M10
Nylon Locknut (21).
Make sure that the Cable is
in the groove of the Pulley and that the Cable
and Pulley move smoothly.
16
15
58
3
20
68
21
66
15
5
5
12
15
66
94
21
57
58
17. Route the Medium Cable (58) over a 90mm
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with an M10 x 45mm Bolt
(12) and an M10 Nylon Locknut (21). Make sure
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move smoothly.
The end of the Medium Cable will be attached
in step 21.
18. Locate the Short Cable (23). Route the Cable
under the 90mm Fortified Pulley (95). Attach the
Pulley and a 16mm x 15mm Spacer (7) to the
lower hole in the Press Frame (17) with an M10 x
93mm Bolt (88), an M10 W
asher (9), and an M10
Nylon Locknut (21). Make sure that the ball on
the Cable is in the indicated position and that
the Cable is between the Pulley and the cross-
bar on the Press Frame.
Route the Short Cable (23) under a 90mm Pulley
(15). Attach the Pulley and a Cable
T
rap (66) to
the lower hole in the Front Upright (42) with an
M10 x 93mm Bolt (88), an M10 Washer (9), and
an M10 Nylon Locknut (21).
Make sure that the
Cable Trap is turned to hold the Cable in
place.
17
18
21
12
Bracket
55
58
42
21
21
88
66
9
9
88
95
7
Ball
15
23
Crossbar
17
15