Owner's Manual

12
19. Route the Short Cable (23) under a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
t
he upper hole in the Press Frame (17) with an
M10 x 83mm Bolt (16), an M10 Washer (9), and
a
n M10 Nylon Locknut (21). M
ake sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
Route the Short Cable (23) under a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the indicated hole in the Front Upright (42) with
an M10 x 93mm Bolt (88), an M10 Washer (9),
and an M10 Nylon Locknut (21).
Make sure that
the Cable Trap is turned to hold the Cable in
place.
20. Attach the end of the Short Cable (23) to the
Long “U”-bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (8). Note: Do not com-
pletely tighten the Locknut; it should be tight-
ened so that only two threads of the Cable
show past the Locknut, as shown in the inset
drawing.
15
15
2
3
88
21
66
66
1
6
9
9
17
42
21
19
57
57
23
3
3
8
20
21. Attach the Medium Cable (58) to a Small “U”-
bracket (71) with an M8 Nylon Locknut (3) and an
M8 Washer (8). Note: Do not completely tight-
en the Locknut; it should be tightened so that
only two threads of the Cable show past the
Locknut, as shown in the inset drawing.
Attach the Small “U”-bracket (71) to the indicated
Weight Tube (63) with an M8 x 45mm Bolt (24)
and an M8 Nylon Locknut (3).
71
24
8
3
58
21
3
23
71
3
58
63