Owner's Manual

14
25. Wrap the Long Cable (72) over a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the Squat Arm (84) with an M8 x 58mm Shoulder
Bolt (97) and an M10 Nut (92). Make sure that
the Nut is on the side shown and that the
Cable Trap is positioned to hold the Cable in
place.
25
1
5
Bracket
84
66
92
97
72
26. See inset drawing A. Note: The inset drawing
shows the view from the other side of the
Squat Upright (56).
Wrap the Long Cable (72)
under a ā€œVā€-pulley (50). Attach the ā€œVā€-pulley and
a Long Cable Trap (31) to the top hole in the
Squat Upright with an M10 x 120mm Bolt (67), a
16mm x 15mm Spacer (7), an M10 Washer (9),
and an M10 Nylon Locknut (21).
Position the
Long Cable Trap as shown.
See inset drawing B. Note: The inset drawing
shows the view from the other side of the
Squat Upright (56). Slide the end of the Long
Cable (72) and two M8 Washers (8) onto the end
of the M8 x 58mm Shoulder Bolt (97). Thread an
M8 Nylon Locknut (3) onto the Bolt. Do not tight-
en the Locknut; there must be room between
the M10 Nut (92, see step 25) and Locknut for
the end of the Cable to pivot.
26
67
31
50
50
A
B
7
9
72
8
3
97
72
72
Insets show view
from other side
56
56
21
27. Attach the Backrest (41) to the Front Upright (42)
with two M6 x 63mm Screws (43) and two M6
Washers (10).
27
SEAT ASSEMBLY
42
41
43
10