Owner's Manual

16
32. Attach the Left and Right VKR Arms (79, 80) to
the VKR Upright (74) with two M8 x 70mm Bolts
(75) and two M8 Nylon Locknuts (3).
32
VKR ASSEMBLY
7
4
79
3
75
75
80
34. Attach the VKR Backrest (77) to the VKR Upright
(74) with two M6 x 63mm Screws (43) and two
M6 Washers (10).
33. Attach a VKR Armrest (78) to the Right VKR Arm
(80) with two M6 x 50mm Screws (81) and two
M6 Washers (10).
Attach a VKR Armrest (78) to the Left VKR
Arm (79) in the same manner.
33
34
78
80
74
43
77
81
79
10
10
78
10
35. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 17 of this manual.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAM on page 21 of this manual for proper cable routing. If there is any slack in the cables, the
cables should be tightened. See TROUBLESHOOTING AND MAINTENANCE on page 20.