Owner's Manual

Welded
Spacers
6
8
Lubricate
Holes
Pin
73
65
63
25
6. Insert the Weight Tube (63) into the rear stack of
Weights (25). Make sure that the pins on the
W
eight Tube are sitting in the pin grooves in
the top Weight.
Lubricate the inside of the holes in the other Top
Weight (65). Set the Top Weight onto the rear
stack of Weights (25). Insert both Short Weight
Guides (73) into the stack of Weights. Make sure
that the holes in the Weight Guides are at the
top, as shown.
7
8
60
61
361
3
55
60
73
62
17
59
Lubricate
Holes
90
T
ube
21
4
7. Attach the upper ends of the Long Weight Guides
(62) to the Top Frame (55) with an M8 x 150mm
Bolt (60), two 13mm x 19mm Spacers (61), and
an M8 Nylon Locknut (3).
Attach the upper ends of the Short Weight Guides
(73) to the Top Frame (55) with a M8 x 150mm
Bolt (60), two 13mm x 19mm Spacers (61), and
an M8 Nylon Locknut (3).
8. Press a 25mm x 22mm Plastic Bushing (90) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place onto the Base
(4).
Note: Make sure that the holes in the
Press Frame are on the side shown. This will
be a tight fit. The Plastic Bushings should fit
on each end of the indicated tube in the Base.
Lubricate the M10 x 200mm Bolt (59). Attach the
Press Frame (17) to the Base (4) with the Bolt
and an M10 Nylon Locknut (21).
ARM ASSEMBLY
Pin
Groove