Owner's Manual

9. Grease an M10 x 135mm Bolt (93). Attach the
Squat Arm (84) to the VKR Upright (74) with the
B
olt and an M10 Nylon Locknut (21). M
ake sure
that the indicated bracket is pointing down as
s
hown. Do not overtighten the Locknut; the
Squat Arm must be able to pivot easily.
Wet the ends of the Squat Arm (84) and the
inside of two Squat Arm Pads (85) with soapy
water. Slide the Arm Pads onto the Squat Arm.
Attach a Handle (82) to one side of the Squat
Arm (84) with an M8 x 62mm Bolt (22), two M8
Washers (8), a 13mm x 13mm Spacer (91), and an
M8 Nylon Locknut (3).
Assemble another Handle (82) to the other
side of the Squat Arm (84) in the same manner.
9
9
8
84
2
2
82
82
21
85
8
3
91
74
93
10. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm.
Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle. Be
careful not to confuse the Right Arm with the
Left
Arm (47). Make sure that the upper end of
the Right Arm is behind the indicated bracket
on the Top Frame (55).
Tap two 25mm Retainers (69) and a 25mm
Round Cover Cap (70) onto the axle. Make sure
that the teeth on the Retainers bend toward
the Round Cover Cap as shown in the inset
drawing.
Wet the lower end of the Right Arm (48) and the
inside of a 252mm Pad (45) with soapy water.
Slide the Pad onto the lower end of the Arm.
Attach the Left Arm (47) in the same manner.
10
69
70
Lubricate
Axle
55
69
70
Axle
48
47
Bracket
Bracket
Welded
Bracket
Grease
45