Owner's Manual

1.
Orient the Center Base (2) so that the warning
decal is in the position shown. Attach one side of
the Center Base to the Base (1) with two M10 x
90mm Bolts (26), two M10 Washers (24), and two
M10 Locknuts (23). Do not tighten the
Locknuts yet.
Repeat this step for the other side of the
Center Base (2).
Before beginning assembly, make sure you
understand the information in the box
above.
1
23
1
2
Decal
24
24
26
6
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• To hire an authorized service technician to
assemble the exercise tower, call 1-800-445-
2480.
• Assembly requires two persons.
• Because of its size, the exercise tower should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the exercise tower as you assemble it.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
•
As you assemble the exercise tower, make sure
all parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• Assembly requires the following tools:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the exercise tower can be assembled suc-
c
essfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.