Owner's Manual

8
6. Attach an M10 x 70mm Bolt (43) to the Front Leg
(
3) and the Frame (1) with an M10 Washer (36)
and an M10 Nylon Locknut (40).
Tighten the M10 Nylon Locknuts (40) used in
steps 2–6.
A
ttach the Front Leg Bumper (25) to the Front Leg
(
3) with an M4 x 16mm Self-tapping Screw (37)
and an M4 Washer (42).
3
1
42
25
43
3
6
40
37
6
7
7. Orient the Backrest Support (9) as shown. Apply
some of the included grease to an M10 x 148mm
Bolt (31). Attach the Backrest Support between
the Backrest Frames (10) with the Bolt and an
M10 Nylon Locknut (40).
Do not overtighten the
Nylon Locknut; the Backrest Support must
pivot easily.
Next, attach the Backrest (11) to the Backrest
Frames (10) with four M6 x 38mm Screws (35)
and four M6 Washers (39).
Do not tighten the
Screws yet.
8. Grease an M10 x 148mm Bolt (31). Attach the
Backrest Frames (10) to the Seat Carriage (6)
with the Bolt and an M10 Nylon Locknut (40). Do
not overtighten the Nylon Locknut; the
Backrest Frames must pivot easily.
Grease an M10 x 80mm Bolt (30).
Attach the
Backrest Support (9) to the Crossbar (2) with the
Bolt and an M10 Nylon Locknut (40). Do not
overtighten the Nylon Locknut; the Backrest
Support must pivot easily.
See step 7. Tighten the four M6 x 38mm Screws
(35).
8
6
Grease
2
11
9
30
40
10
31
11
35
40
35
9
31
39
10
Grease
Wide
End
39
40